## Abstract

This paper reports the effect of changing the aspect ratio on the heat transfer and flow quantities over in-line tube banks. Two types of in-line arrangements were employed; square and non-square configurations. The models that were examined are a standard k-ε model, SST k-ω model, v2-f model, EB k-ε model and EB-RSM model. The closer results to the experimental data and LES were obtained by the EB k-ε and v2-f models. For the square pitch ratios, the solution has faced a gradual change from a strong asymmetric to asymmetric and then to a perfect symmetry. The strong asymmetric solution was found by the very narrow aspect ratio of 1.2. However, the behaviour of cases of 1.5 and 1.6 became less strong than that predicted in the case of 1.2. In the larger aspect ratio of 1.75, the flow behaviour is seen to be absolutely symmetric for all variables under consideration except Nusselt number. For the very large pitch ratio of 5, the flow has recorded maximum distributions for all parameters on the windward side of the central tube with a perfect symmetric solution around the angle of 180° while the vortex shedding frequency has recorded minimum value and the Strouhal number; therefore, has given the smallest value. However, for the non-square pitch ratio of constant transverse distance, the solution is still asymmetric for all parameters with merely one stagnation at the angle of 52° at the case of the 1.5 × 1.75 while by increasing the longitudinal distance to 2 and 5, the solution provided a comprehensive symmetry for all variables with two vortices are fully developed mirrored in shape on the leeward side of the central tube. On the contrary, for the non-square pitch ratio of constant longitudinal distance, the flow of the case of 1.75 × 1.5 provided two stagnation locations at around 52° and 308° with a very similar solution to the case square ratio of 1.75 for all variables whereas by increasing the transverse distance to 2 and 5, the solution recorded was not perfectly symmetric resulting in two different vortices and one stagnation position located at the leading edge of the cylinder provided by the case of 5 × 1.5. In terms of vortex shedding effect, the reduction in the Strouhal number at a constant transverse pitch is less steep than those at a constant longitudinal pitch.

Original language | British English |
---|---|

Pages (from-to) | 18-30 |

Number of pages | 13 |

Journal | International Communications in Heat and Mass Transfer |

Volume | 89 |

DOIs | |

State | Published - Dec 2017 |

## Keywords

- Flow quantities
- Heat transfer
- Inline tube bundles
- URANS turbulence models